THE EFFECT OF TURNING PARAMETERS ON THE RESPONSES
Journal: International Journal of Engineering Sciences & Research Technology (IJESRT) (Vol.6, No. 7)Publication Date: 2017-07-30
Authors : Ch. Maheswara Rao; R. Varaprasad; S. Srikanth;
Page : 725-731
Keywords : Material removal rate (MRR); Surface Roughness (Ra); Taguchi and ANOVA.;
Abstract
The present work is to explore the effect of cutting parameters on the material removal rate and surface roughness while turning of EN19 steel using tungsten carbide insert. For the experiments, cutting speed, feed and depth of cut were considered as input parameters at three different levels. The experiments are conducted as per the taguchi's standard L9 Orthogonal array. From the taguchi results, the optimal combination of cutting parameters for material removal rate is found at: v3-f3-d3. The optimal combination of cutting parameters for surface roughness is found at v3-f1-d1. The ANOVA results showed that, the cutting speed and the feed are the most dominant factors in effecting the material removal rate and surface roughness respectively
Other Latest Articles
- AN EXPERIMENTAL APPROACH FOR BEHAVIOR ANALYSIS OF SISAL EPOXY COMPOSITES
- LINEAR AND NON LINEAR OPTICAL QUALITIES OF L-HISTIDINIUM 2- NITROBENZOATE NLO CRYSTAL
- DESIGN AND SIMULATION OF EXTERNAL MODULATION TECHNIQUE BASED RADIO OVER FIBER (ROF) COMMUNICATION SYSTEM
- OPTIMIZATION OF AIRCRAFT MAINTENANCE DOWNTIME BY HARMONIZING LIFE OF COMPONENTS DURING MAJOR OVERHAUL
- IMPACT OF MUDRA LOAN SCHEME ON MICRO & SMALL PRINTING UNITS
Last modified: 2017-07-31 19:52:54