OPTIMIZATION OF THE SOLDERING PROCESS BY THE DMAIC METHODOLOGY
Journal: PRODUCTION ENGINEERING ARCHIVES (Vol.2016, No. 11)Publication Date: 2016-06-30
Authors : Michał Zasadzień;
Page : 6-10
Keywords : improvement; process; soldering; six sigma; production; quality;
Abstract
The chapter presents the use of the DMAIC method for the analysis and improvement of the process of soldering pins in a plug connecting a bundle of wires to the board of a controller; a part of the steering system of a car. The main problem in the soldering process, that is an unsatisfactory share of bad soldered connections between the board and the plug and the instability of that number, was identified by means of a five-phase improvement process. Key points and main causes of the defect were pointed out, and process improvement measures were suggested. Due to the analysis conducted and the correct implementation of improvement measures the share of defective connections has been decreased twofold.
Other Latest Articles
- PROCESSING AND UTILIZATION OF METALLURGICAL SLAGS
- ENGINEERING PRODUCTION EDUCATION IN E-LEARNING EXAMPLE IN POLAND
- Social capital and social entrepreneurship and innovation culture
- ANALYSIS OF CAUSES AND EFFECTS ERRORS IN CALCULATION OF ROLLING SLEWING BEARINGS CAPACITY
- TENDENCIES IN THE DEVELOPMENT OF MODERN SACRAL ARCHITECTURE ON THE EXAMPLE OF THE ARCHDIOCESE OF CZESTOCHOWA
Last modified: 2018-03-20 20:44:47