Optimization of Welding Modes for High-Strength Low-Alloy Domex 700 Steel
Journal: Ukrainian Journal of Mechanical Engineering and Materials Science (Vol.3, No. 2)Publication Date: 2017-12-26
Authors : Andrii Dzyubyk; Volodymyr Palash; Ivan Khomych; Stanislav Hrynus;
Page : 47-54
Keywords : DOMEX 700 steel; experiment planning; weld joint; microhardness; area of hardening; thermal impact zone; high strength steel; microstructure;
Abstract
The microstructure and hardness of the weld joints of DOMEX 700 steel were investigated. As a result, the optimization of the parameters of robotic arc welding in the environment of protective gases was carried out taking into account the size of the energy per unit length. The optimum modes of welding were determined. The size of the deterioration area, where there is a decrease in hardness in comparison with the main metal, for a thickness of 6 mm is 2.36 mm, and for a thickness of 3 mm is 1.51 mm. The parameters of the robotic welding process in the arc mode in the environment of protective gases for the investigated thicknesses of the DOMEX 700 steel were recommended. As a result, the energy-saving conditions for welding performing were achieved ensuring the required technological strength.
Other Latest Articles
- Determination of Stresses and Ultimate Loads for Composite Plates with Elastic Inclusions
- Gears with Asymmetric Tooth Profiles and New Alternative Method of Their Manufacturing
- Influence of the Technological Gap Value of the Tool-Joint Tapered Thread on the Drilling Mud Flow Rate in Its Screw Coupling
- Investigation of the Carbide-tipped Tool Wear Hardened by Method of Aerodynamic Impact
- On Free Oscillations of a Quadratic Nonlinear Oscillator
Last modified: 2018-04-24 05:51:14