Evaluation of positional accuracy of digital topographic maps at scale 1:25 000 (DTM25) on the basis of STANAG 2215 standard
Journal: VOJNOTEHNICKI GLASNIK / MILITARY TECHNICAL COURIER (Vol.66, No. 1)Publication Date: 2018-01-01
Authors : Siniša M. Drobnjak; Branko S. Božić;
Page : 106-121
Keywords : positional accuracy; STANAG 2215 standard; digital topographic maps; Military Geographical Institute;
Abstract
The paper describes the results of the positional accuracy assessment of digital topographic maps at scale 1: 25 000 produced by the Serbian Military Geographic Institute (MGI). The test for the horizontal and vertical accuracy compliance of map sheets is done by comparing the planimetric and height coordinates of the ground points to the coordinates of the same points as determined by a check survey of higher accuracy. In this research STANAG 2215 standard was used and the methodology of its use is discussed in detail. The results of positional accuracy assessment for the digital topographic maps at scale 1:25 000 produced by the Military Geographic Institute have confirmed the highest level of accuracy defined by STANAG 2215 standard.
Other Latest Articles
- Numerical modeling of the impact of projectiles on metal structures
- Determining the dynamic characteristics of hydraulic excavators
- Mechanical properties and microstructures of bio-inert layers of chrome oxide coatings deposited by the APS process
- Estimate of projectile initial velocity as a solution of a two-point boundary value problem
- Some critical remarks on the paper “A note on the metrizability of tvs-cone metric spaces”
Last modified: 2018-04-24 16:55:47