FABRICATION OF ELECTROMAGNETIC ENGINE USING PULL FORCE
Journal: International Journal of Advanced Research (Vol.6, No. 4)Publication Date: 2018-04-06
Authors : Raj Solanki Sushil Thakkar Khushali Sheth; Harsh Sheth.;
Page : 152-159
Keywords : Electromagnet plunger piston-cylinder crank shaft flywheel transformer-rectifier.;
Abstract
In our modern scenario with increasing population use of energy resources such as fuels from crude oil increases and the amount of resources decreases as the time increases. So, in near future there will be limited amount of fuel to overcome this problem the project focus on the zero-fuel consumption. The working principle is based on the electromagnetism. Here the hollow cylinder contains coil which produce the magnetic field and at top of the piston is made up of the ferrous rod. When the current is supplied due to pulls force of the solenoid the ferrous rod gets pulled with great amount of force. Thus, the reciprocating motion is achieved, and some IC engine components and electronic circuits are used to control the motion.
Other Latest Articles
- EFFECTIVENESS OF YOGA AS MIND-BODY EXERCISE OVER MEMORY, PERCEIVED STRESS AND MENTAL HEALTH
- TREACHER COLLIN?S SYNDROME: A CASE REPORT WITH AN AUGMENTED REVIEW!
- SOIL FERTILITY STATUS OF MULBERRY (MORUS ALBA L.)SOILS UNDER BIVOLTINE SERICULTURAL AREAS OF NORTH, SOUTH AND EASTERN REGIONS OF KARNATAKA
- A STUDY OF DM TECHNIQUES IN SOFT COMPUTING FRAMEWORK
- INCREASED OXIDATIVE STRESS REDUCES THE LEVEL OF SERUM PARAOXONASE-1(PON-1) AND OTHER BIOCHEMICAL MARKERS IN PATIENTS WITH PULMONARY TUBERCULOSIS (PTB) IN NEPALESE POPULATION
Last modified: 2018-05-25 18:38:52