Influence of Addition of Silicon on Mechanical Properties of Aluminium – Zinc Alloy
Journal: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) (Vol.8, No. 2)Publication Date: 2018-04-30
Authors : S. Arunprasad G. Abhishek Bharadwaj M. Karthik Krishnan; J. Harikrishna Arunkumar;
Page : 113-120
Keywords : Aluminium-zinc alloy; silicon; Yield Strength; Ultimate Tensile Strength & Hardness;
Abstract
In this investigation, the experiment was conducted to analyze the mechanical properties such as Yield Strength, Ultimate Tensile Strength, Hardness on Al-Zn alloy of different composition Specimen 1 (89.4%Al4%Zn1%Mg0.6%Mn) , specimen 2 (86.4%Al4%Zn1%Mg0.6%Mn), specimen 3 (84.4%Al4%Zn1%Mg0.6%Mn) by the addition of 5%, 8% and 10% silicon. It was found that the mechanical properties were improved by the addition of silicon. It was noted that the maximum yield strength 103 N/mm2, Ultimate Tensile Strength of 116 N/mm2 and Hardness of 60.9BHN were obtained for the addition of 10% silicon to aluminium-Zinc alloy. Also, SEM (Scanning Electron Microscope) analysis was taken and presence of silicon content was analyzed.
Other Latest Articles
- Manufacturing of Proto Type Wind Turbine Blades Using Rapid Prototype Technology
- Rail Road Wheel Requirements and Manufacturing Processes
- Experimental Investigations on Dual Bio-Fuel (Pine Biodiesel and Palm Biodiesel) Blended with Diesel on a Single Cylinder Diesel Engine
- Information on State of Challenges of Waste Management System in Nigeria Urban Housing System
- MANAGING ROLE CONFLICT: NEW CHALLENGES BEFORE WORKING WOMEN
Last modified: 2018-07-20 18:31:56