Optimization of Process Parameters on Thrust Force and Delamination Factor in Drilling of Carbon Fiber Reinforced Composites
Journal: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) (Vol.8, No. 2)Publication Date: 2018-04-30
Authors : Veereshchandra. M. S Kishore Kumar. N Bharath. V Chandan. N; N. Chikkanna;
Page : 567-574
Keywords : CFRP (Carbon Fiber Reinforced Polymer); Drilling; Taguchi; ANOVA; Delamination; Thrust Force & Optimization;
Abstract
The major objective of this work was to investigate a statistical model, based on Taguchi technique and to estimate the quality of drill in CFRP composite material prepared by hand layup technique. The design of experiments were made to investigate the influence of drill parameters such as cutting speed, feed rate and drill diameter on thrust force and delamination factor in drilling of CFRP laminates. Analysis of variance (ANOVA) was used to analyze the significance level of every drill parameters. The statistical model yields the results showing that the speed and feed rate were the major parameters affecting significantly the drilling process. Delamination due to drilling was analyzed by the stereomicroscope.
Other Latest Articles
- Review on Electric Vehicles
- Properties of Self Similar Solutions of Reaction-Diffusion Systems of Quasilinear Equations
- Study of the Behaviour of Hybrid Nano Jute Fiber Composite under Impact Loads
- Processing and Mechanical Testings of 7075 AL Matrix Composite Reinforced with AL2O3 Nano-Particles Fabricated by Stir Casting Route
- Model of Estimation of Success of Geological Exploration in Perspective
Last modified: 2018-07-23 20:24:19