Modeling and Simulation of Solar Photovoltaic System

Solar energy is a vital untapped resource in a tropical country like ours. The main hindrance for the penetration and reach of solar PV systems is their low efficiency and high capital cost. The efficiency of solar PV is very low. In order to increase the efficiency, Maximum Power Point Tracking (MPPT) techniques are to be undertaken to match the source and load property. These techniques are employed in PV systems to make full utilization of PV array output power. Recently, many MPPT algorithms of PV system have been proposed which depends on solar irradiation and temperature, but perturb and observe (P&O) and Incremental conductance algorithms are basic and most widely used. This project firstly introduces a Mat lab Simulink of photovoltaic array. To achieve the maximum power point tracking the Incremental Conductance method and perturb and observed (P&O) method are used. These two algorithms are employed with PV model along with converter in Mat lab Simulink. Three different converter boost, buck boost and cuk converter are design according to requirement and used. Few comparisons such as voltage, current and power output for each different combination have been recorded. Irfan Khan | Ameen Uddin Ahmad"Modeling and Simulation of Solar Photovoltaic System" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-6 , October 2017, URL: http://www.ijtsrd.com/papers/ijtsrd5743.pdf http://www.ijtsrd.com/engineering/electrical-engineering/5743/modeling-and-simulation-of-solar--photovoltaic-system/irfan-khan