Properties of MIM 4140 Alloy After Injection Molding and Sintering
Journal: International Journal of Innovation Engineering and Science Research (Vol.2, No. 1)Publication Date: 2018-01-30
Authors : Denis Chemezov;
Page : 5-10-14
Keywords : a casting; a mold; MIM 4140 alloy; a surface layer; injection molding.;
Abstract
Testing results of a multi-cavity mold for injection molding of MIM 4140 alloy are presented in the article. Recommendations for manufacturing of forming parts of the mold were given. Based on an implemented technological process of casting and subsequent laboratory researches an information was obtained about the condition of a casting (hardness on Super-Rockwell, shrinkage and quality of a surface layer of material before and after heat treatment). Calculated overall dimensions of the forming parts of the project mold will allow making forecast of shrinkage of MIM 4140 alloy after injection molding.
Other Latest Articles
- Internet of Things (IoT) and its Challenges for Usability in Developing Countries
- The Hydrological Functioning of the Watershed of Lake Laya- El Hammam, East of Tunisia
- Development of Regional Infrastructure and Regional GDP Inequality in Indonesia
- Probabilistic Polling System Approach for IoT Secure Routing
- WIDEBAND MONOPOLE ANTENNA POR HF AND VHF
Last modified: 2018-10-14 15:39:31