Design and Analysis of Ceiling Cable Holder Base

Injection moulds are classified into two types based on runner design i.e. Cold runner moulds and Runner less moulds i.e. hot runner moulds. In cold runner moulds, for multi cavity and multi point injection moulds, there is wreckage of material in runner area. Also wastage of material is more than component weight. To overcome the above problem, the technique used is hot Runner moulds. Hot runner mould is one of the improved manufacturing techniques for multi cavity type moulds. These types of moulds are commonly used for large production rate. While producing plastic components using normal standard multi cavity mould, we are facing the problems like partial filling, cavities in components, less product quality, injection pressure and temperature reduction and war page etc. Thus we are redesigning the holder base by doing some modification in and this will be beneficial for our using purpose. We are making design of the component, mould flow analysis using software Solid works. Nitish Kumar Mishra | Prof. Vaibhav Bankar "Design and Analysis of Ceiling Cable Holder Base" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-4 , June 2019, URL: https://www.ijtsrd.com/papers/ijtsrd23840.pdf