DFM & Simulation for Injection Mould of Knob
Journal: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) (Vol.9, No. 5)Publication Date: 2019-10-31
Authors : Minshi Krishna Koya K. Siva Prasad M. Siva Krishna G. Vikas Reddy; Venkata Reddy Sangana;
Page : 265-276
Keywords : Injection Moulding Simulation; Hyper Mesh; Mould Flow Software & Warpage Effects;
Abstract
This work deals with injection moulding simulation of Knob, in which the gate location, diameter and the possible defects during the filling& packing phase is determined and warpage effects under variable shrinkage with process parameters. In this simulation process is carried out by using Hyper mesh and Mould Flow Software. In the Hyper mesh phase, meshing works are carried along with thickness assignment. In the Mould Flow phase, material flow, positioning of gate location, gate size and analysis of defects are determined here. The component tested virtually is Knob that used to set/tune the time for a wash in Washing machine
Other Latest Articles
- Estimation of Damping Derivatives for Delta Wings in Hypersonic Flow for Straight Leading Edge
- Rationalization of Exhaust System Mounting Brackets for Buses and Trucks
- Experimental Investigation of Enhancement Heat Transfer by Natural Convection from Four Finned Cylinders in a Vertical Array Placed in a Conduit
- Calculating Optimum Gear Ratios of Mechanical Driven Systems Using Three Step Bevel Helical Gearbox and Chain Drive for Minimum System Height
Last modified: 2019-11-13 13:44:10