VIBRATION MEASUREMENT ON CUTTING TOOL UNDER VARIOUS OPERATING CUTTING PARAMETERS
Journal: International Journal of Design and Manufacturing Technology (Vol.12, No. 2)Publication Date: 2021-09-13
Authors : Nagesha N; B S Praveen Kumar;
Page : 1-17
Keywords : Machine Tool; Cutting Tool; Vibrometer; RS232 Cable; MAT Lab Software;
Abstract
Machining and measuring operations are invariably accompanied by relative vibration between work piece and tool. The effect of vibration is excessive stresses, undesirable noise, looseness of part and partial or complete failure of parts. In this work the cutting tool vibration will be measured by using digital Vibrometer, which can measure displacement velocity, acceleration and frequency. The sensor will be attached with the tool post for sensing the vibration tool during turning operation. Vibration also increases in the cutting tool due to whiling of the job mounted between two stocks of lathe machine. With the increasing feed rate, the surface roughness of work will increase. The feed rate can be considered as a main cutting factor in the machining operation. The mildsteel material will be used for collecting data at various cutting parameters like depth of cut, speed, feed rate etc. on the completion of experimental work data will be analysing using MATLAB. By doing the same we will be able to predict behaviour for the system under any operating cutting parameters.
Other Latest Articles
- READING BEHAVIOUR OF RESEARCH SCHOLARS IN DIGITAL ENVIRONMENT DURING COVID-2019 PANDEMIC SITUATION: A STUDY AMONG UNIVERSITY OF AGRICULTURAL SCIENCES, RAICHUR
- BEHAVIOR OF PILED RAFT FOUNDATION IN SOFT CLAY LAYER WITH GEO-FOAM APPLICATION
- EVALUATION OF PHYSICO-CHEMICAL PROPERTIES AND DURABILITY ON SELF CURING CONCRETE BY USING PEG AND SAP
- OPTIMIZATION OF QoS REQUIREMENTS FOR APPLICATIONS
- RECOVERY ENGINEERING OF EX-ILLEGAL SAND AND STONE MINING ON THE SLOPES OF MOUNT MERAPI
Last modified: 2021-09-13 16:29:35