Improving the Speed Control of the Induction Motor Using Pulse Width Modulation Technique
Journal: American Journal of Applied Sciences and Engineering (Vol.3, No. 3)Publication Date: 2022-31-3
Authors : Ilo Fredrick U.; Echegi Judith U.; Echegi Christian U.;
Page : 1-11
Keywords : Speed Setpoint; Induction Motor; Torque; Pulse Width Modulation;
Abstract
In this research, the improvement of the speed control of the induction motor using the pulse width modulation (PWM) technique was carried out. The induction motor is subjected to characterization to evaluate its essential parameters of functionality. The speed characterization of the induction motor was obtained by the application of the phase angle control method under the two operating conditions. The induction motor was operated at a setpoint speed 2830RPM and rated with torque 10Nm. In the second part, the induction motor was operated at 50% of rated torque (5Nm) and a speed setpoint of 50% of the rated speed (1415 RPM). It was observed that the torque obtained is inversely proportional to the speed. At about 0.15 seconds the speed rose to a maximum of 3152.9RPM, which represents an overshoot of about 10.24% with a settling time of 0.3 7sec. While the setpoints speed at 50% of the rated speed and loaded mark with 50% of the rated torque, it took the induction motor a long time to match the speed setpoint. The settling time is about 0.44sec while the overshoot recorded is about 26.60%. Due to faster settling time and favourable overshoot obtained by the induction motor in the study, the speed response characteristics exhibited higher efficient operation and better energy utilization
Other Latest Articles
- Energy Efficiency Improvement of Doubly-fed Induction Generator Using SelfTuning Adaptive Control Technique
- Non-linear System Identification and Control for Autonomous Robot Using Artificial Neural Network
- Development of an Intelligent Solar-Powered Immunization Vaccine Storage System
- Reduction of Outages in Transmission Using Real-Time Technique
- Design Procedure and Development of a 100kw Solar Power Inverter for Off-Grid Industrial Use
Last modified: 2022-08-25 17:48:14