Increasing the stability of the fire extinguishing foam by replenishing the liquid phase during sprinkling

Introduction. The destruction of foam films occurs when they reach critical thickness and lose the liquid phase as a result of syneresis and evaporation, which are rather difficult to slow down. We have proposed a method for increasing the stability of the fire extinguishing foam by means of replenishing the liquid phase through sprinkling. Methods. Foam stability was measured by the time of destruction of 25 % of the initial foam volume. The concentration of the foaming agent in the sprinkled solution varied from 0.5 to 6 %. Carboxymethylcellulose sodium salt (Na CMC) was used as a stabilizing additive. Field studies were carried out by feeding foam and solution from two AT-3,2-40 (43253)001-MS tank cars. Results and discussion. It has been established that the foam stability is influenced by the sprinkling intensity and the foaming agent concentration. Foam sprinkling with the solutions having low concentration of thefoaming agent leads to the washout of surfactants from the films that reduces the foam stability. The sprinkling intensity reduction boosts the foam stability due to the replenishment of the moisture lost through evaporation. The foam stability was maximal in case of sprinkling with a 2 % solution of the foaming agent, while the sprinkling intensity had no influence. An increase in the concentration of the foaming agent in the sprinkled solution led to a decrease in the foam stability. It is found that a smaller amount of the foaming agent is consumed to maintain the amount of foam through sprinkling than to replenish the destroyed amount through additional foam generation. It is shown that various stabilizing additives can be added to the foam in the process of sprinkling. If Na CMC is added to the solution exposed to sprinkling, the time of foam destruction goes up 3–5 times even in case of a non-recurrent sprinkling session. Field tests have confirmed the feasibility of adding stabilizing additives to the foam by means of sprinkling. Conclusions. The results of the research have shown the feasibility of co-feeding the foam and surfactant solutions, containing various stabilizing additives, in order to extinguish fires and generate stable foams.