Use of turbidimetry for determination of heat treatment intensity applied at pasteurization of milk

Express methods for estimating the intensity of heat treatment of milk are necessary in industry and in research work. For this reason, there are many ways to measure this parameter, which are based on different physical principles, including turbidimetric methods. The Harland & Ashworth turbidimetric method has been developed for a long time, however, due to its high reliability and ease of implementation, it is still used in practice. However, this method has a drawback: it takes a long time to perform the analysis. In this regard, the aim of the work is to develop an express method for evaluating the thermal class of milk based on the principle of measuring the concentration of soluble whey proteins. The result is achieved through the use of a turbidimetric measurement method with optimized sample preparation parameters and parameters for measuring the optical density of a suspension of protein aggregates. The method is implemented as follows. The milk sample is mixed with 0.1 N acetate buffer (pH 4.6) in a ratio that allows to obtain a concentration of soluble milk whey proteins from 0.05% to 0.1%. Recommended dilution coefficients: 1:3 for samples of ultra-pasteurized milk and pasteurized milk with high heat treatment intensity; 1:7 for samples of pasteurized milk with low heat treatment intensity and 1:14 for raw milk samples. The solution is filtered on a membrane filter with a pore size of 0.45 microns. The resulting filtrate is mixed with 24% trichloroacetic acid (TCA) in a 1:1 ratio to coagulate soluble whey proteins and form protein aggregates. After holding for 5–10 minutes, the optical density of the suspension of protein aggregates is measured at a wavelength of 650 nm. The content of water-soluble whey proteins in the sample can be calculated according to the calibration curve. The developed method allows to obtain the measurement result in less time than the Harland & Ashworth turbidimetric method.