Lead-acid batteries life time prolongation in renewable energy source plants

Charge controllers with microprocessor control are recognized to be almost optimal process control devices for collecting and storing energy in batteries in power sys-tems with renewable energy sources such as solar photoelectric batteries, wind electrogenerators and others. The task of the controller is charging process control, that is such as charging and discharging the batteries while providing maximum charging speed and battery saving parameters that characterize the state of the battery, within certain limits, preventing overcharging, overheating and the batteries deep discharge. The possibility of archiving data that keeps the battery parameters time dependance is also important. Thus, the concept of a charge controller with Texas Instruments microcontroller device MSP430G2553 was introduced in the study. The program saved in the ROM microcontroller provides for: charge regime(with a particular algorithm); control and training cycle followed by charging; continuous charge-discharge regime to restore the battery or the study of charge regime algorithms influence on repair effectiveness. The device can perform its functions without being connected to a personal computer, but this connection makes it possible to observe in real time the characteristics of a number of discharge and charge regimes parameters, as well as reading the stored data from microcontroller flash memory and storing these data on the PC hard disk for further analysis. A four stages charging algorithm with reverse charging regime was offered by the author and correctness of algorithm was proved