Evaluation The Effect Of Machining Parameters For MRR Using Turning Of Aluminium 6063Journal: International Journal for Scientific Research and Development | IJSRD (Vol.3, No. 10)
Publication Date: 2016-01-01
Authors : Sudhir; Karun; Neeraj kumar;
Page : 458-459
Keywords : Taguchi Design; Orthogonal Array; Turning; cutting speed; feed;
Turning is a basic operation for various industries & it is very essential to optimize the various parameters affecting turning for the optimum condition. Turning operation is affected by both machining parameters & Cutting fluids. The parameter influence most are cutting speed, depth of cut , feed, geometry of cutting tool like principle cutting edge angle ,rake angle, nose radius etc. In order to control MRR it is very necessary to control these parameters. In the project turning operation the different values of cutting parameters, cutting speed (45, 90,140,330), feed rate (.1, 22, 44, 68 mm/rev), depth of cut (.5, 1, 1.5,2 mm) are selected. MRR is largely influenced by Speed then Feed then DOC. MRR shows an increasing trend with increasing Speed. MRR shows an increasing trend with increasing Feed. MRR shows an increasing trend with increasing DOC.
Other Latest Articles
Last modified: 2016-01-07 18:49:32