The research of regularities in finding shape errors and roughness in cut-in centreless grinding of driveshaft cross-piece journals in accordance with the coolant composition and its supply scheme to the grinding area
Journal: Engineering industry and life safety (Vol.10, No. 2)Publication Date: 2013-06-30
Authors : Blurtsyan D.R. Blurtsyan R.S. Blurtsyan I.R.;
Page : 49-53
Keywords : shape errors; roughness; centreless grinding; cross-piece; composition; coolant supply scheme;
Abstract
The paper presents the research results of shape errors and roughness of driveshaft cross-piece journal surfaces in cut-in cenreless grinding in accordance with the coolant composition and its supply scheme into the grinding area. The results will provide increasing the quality of driveshaft cross-piece journal surfaces. The dependence of shape error change and specification on roundness and cut are considered in the course of the research work as well as ground surface parameters (Ra, Rz) depend on the coolant composition and its supply scheme to the grinding area in cut-in cenreless grinding of driveshaft cross-piece journals. The paper considers the influence of emulsol, which is a water solution, and NGL-205 coolant on developing the shape roughness and error parame-ters in centreless grinding. Roughness parameter measurements are conducted with the use of profilometers-profilers of various designs. Shape error parameter measurements are performed using bore gages when record-ing polar diagrams followed by their processing. The results of the research have been implemented in manufac-turing driveshaft cross-pieces.
Other Latest Articles
- Problem of cranes exploitation with dangerous defects
- Determination of karst collapse intensity from incomplete data
- Improvement of monitoring residential areas of ecological and economic systems
- Technical diagnostics of the contactless transformer sensors blocks of geodynamic monitoring system
- The use of the seismoelectric method in natural and technical systems geodynamic control
Last modified: 2013-08-29 00:36:22