Desain dan pembuatan pakaian kerja kulit

The preparation of leather custom for hard workers was aimed to increase the diversification of leather good products garment, to obtain a practical and simple method of leather garment preparation, as well as to seek suitable fashion of hard workers wear. Eight designs prepared, of leather costum for hard workers followed by selection of the most favourite designs by ten panelists. Based on the selected designs, the leather costum were then prepared. The manufacturing of the leather garment was carried ? out in sequence of the following works, basic pattern preparation performed in mass production system, in standard size, material cutting, preparation for assembling and stitching. Three pieces of leather garment for hard workers were produced in size 48 (M) for this purpose, where as the most favourite designs were 1, 2 and 3. Leather garment for hard workers of designs one, two and three met good marks, while design 1 was fair. Technology of manufacturing obviously affected the quality of leather garment for hard workers, as well as the selection of the raw materials quality. The result of study could be presented as the following design one for quality of material was fair. Design two and three met good mark for the higher quality of raw material was utilized to manufacture high quality leather garment for hard workers some considerations should be taken, they are : economical use of raw material; practice simple styles; and proporsional lines and sizes. The conformity of the technical requirements will produce sound quality products