STUDYING OF OPEN LOOP CONTROLLER ON DRIVE SYSTEM
Journal: International Journal of Engineering Sciences & Research Technology (IJESRT) (Vol.5, No. 5)Publication Date: 2016-05-30
Authors : Belqasem Aljafari;
Page : 44-48
Keywords : Power processing unit (PPU);
Abstract
A control system is an interconnection of components shaping a system configuration that will give the required system response. The basis for analysis of a system is the foundation provided by a linear system, which assumes a cause - effect relationship between the components of a system. An open - loop control system uses a controller to gain the desired response. The open - loop control system is used to control the process by an input signal direct ly without taking benefits of feedback. The open - loop system does not use feedback to determine if the output has achieved the desired target of the input. Hence, the system will not observe the output of the processes that it is controlling. As a result, an open - loop system would not correct any errors that it would happen. The objective of this laboratory procedure was to measure and investigate certain parameters and characteristics about an open loop, alternating current (AC) motor drive system .
Other Latest Articles
- ACTIVITY BASED COSTING - A TOOL TO CONTROL THE COST
- RECONSTRUCTION OF SURFACE FOR IMAGE PROCESSING
- A STUDY PAPER HOW LATEST TECHNOLOGIES LIKES TABS AND DIGITAL MEDIA CAN PROVIDE EFFICIENT WAY TO LEARNING AND EDUCATION
- DESIGN AND STRUCTURAL ANALYSIS OF A WIND TURBINE BLADE WITH MICRO TABS AND RIBS USING DIFFERENT MATERIALS
- INVESTIGATIONS ON HYBRID PARTICLE SWARM OPTIMIZATION TECHNIQUE TO SOLVE OPTIMAL LOAD DISPATCH PROBLEMS WITH PROHIBITED OPERATING ZONES AND RAMP - RATE LIMIT CONSTRAINTS
Last modified: 2016-05-06 22:56:51