TO STUDY AND ANALYSIS OF A MICRO MECHANICAL MODEL OF TWO DIFFERENT HARD STEEL OF DIFFERENT COMPO SITION BY VOLUME ELEMENT METHOD
Journal: International Journal of Engineering Sciences & Research Technology (IJESRT) (Vol.5, No. 9)Publication Date: 2016-09-30
Authors : Harshita Gupta; Anshuka Srivastava; Prabhat Kumar Sinha;
Page : 554-565
Keywords : DP800 steel; representative volume element (RVE) method; ABAQUS software; flow curves of the steels; onset of necking; optimum element type and mesh;
Abstract
This work presented the Micromechanical modeling of flow curve of DP800 steel in uniaxial tension was studied using the representative volume element (RVE) method. Digimat and ABAQUS software were coupled and used to provide the required RVE model parameters and to perform simulations. Modeling results were validated using the experimental flow curves of the steels. It was found that the flow cu rve of DP800 steel was accurately predicted from the onset of plastic deformation up to the onset of necking. The RVE size of 12.7x12.7x12.7 μm and 7.9x7.9x7.9 μm containing 26 martensite islands were found as the optimum RVE sizes for DP800 steel. A mesh of C3D4 elements having a size of 0.050 μm was found to be the optimum element type and mesh.
Other Latest Articles
Last modified: 2016-09-26 18:26:03