AVAIL TOTAL ADVANTAGE — ADDITIONAL CRITERION OF THE FIRE HOSES CHOICE

Fire hoses alongside with other fire equipment are one of the main types of it. The efficiency and success of fire brigades activities depends or its good condition. The use of hoses has requirements for the reliability of their work. The failure in this mode is the most dangerous, because the time to repair failures significantly increases the time required to extinguish the fire. It is well known that currently, more than 10 domestic and foreign manufacturers produce different sets of fire hoses. Therefore, the choice of a particular manufacturer of modern fire hoses, that minimize time for maintenance and prevention, from the hoses-analogues is very difficult for the specialist because of the lack of uniform criteria. Previously it was shown that for the choice of equipment the specialist can apply the integral indicator the mathematical expectation of damage from the loss of his health.We made the assumption that indicator of the relative common benefit can be used for justification of the choice set fire hoses. Moreover, the higher the value of this benefit, the more reliable and relatively effective is one or the other set. Because the worst result of fire is temporary incapacitation (or failure) of fire hoses with a subsequent slower rate of fire, damage from the specified failure will primarily depend on the mortality and severity of diseases associated with slowing of the rate of extinguishment (using the value of human life.). For testing we have selected the three most important characteristics of the four sets of hoses “Latexonly”, “Armtex”, “Getex”, “Standard”, manufactured according to State Standard 51049–2008. The results of the calculations show that the highest common benefit (compared with other hoses) has “Armtex”. Although the purchase price of these hoses is lower than the most expensive hoses, and the total benefit is 7 %higher (the level of technogenic risk is also lower in 1.11 times than the cheap hoses — “Standard”). Therefore, the previously proposed approach to the assessment of reliability on example, of a hydraulic rescue tool (using risk indicators) can be used to determine the most reliable fire and rescue equipment, including fire hoses.