Electrochemical activation as a fat rendering technology

Introduction. The existing methods of animal fat obtaining have certain disadvantages, hence fat extraction study highly is relevant. Electrochemically activated solutions are known to have a great potential for animal fat extraction. The present paper introduced a new advanced fat obtaining technology based on the principle of electrochemical activation. Study objects and methods. The research featured ostrich fat obtained by wet rendering in water and in an electrochemically activated solution (catholyte) using various processing methods and technological parameters. Standard methods helped define the physical and chemical parameters of the obtained fat samples. Results and discussion. The paper introduced a technological and hardware setup of an ostrich fat production line with the necessary equipment specifications. The research made it possible to define the optimal parameters for fat extraction: the salt concentration for the catholyte = 4 g/100 cm3, voltage = 40–42 V, pH = 11, and redox potential of the catholyte = between –600 and –700 mV. During the fat processing, cell membranes in the electrolyte were destroyed, which inactivated the enzyme system. The obtained combination of physical and chemical factors resulted in ostrich fat of high quality. Fat extraction in an electrochemically activated solution (catholyte) catalyzed the process and increased the fat yield, regardless of the processing temperature. The fat yield exceeded 58% at 55°C and catholyte pH of 11.0. At 95–100°C and pH of 9.5–10.6, it exceeded 95%. Conclusion. The new technology increased the fat yield, maintained its high quality, and reduced the processing cost. Therefore, the developed production line could be recommended for fat extraction of farm animals, depending on the intended use.