ResearchBib Share Your Research, Maximize Your Social Impacts
Sign for Notice Everyday Sign up >> Login

FRICTION TORQUE IN THE SLIDE BEARINGS

Journal: Bulletin of Prydniprovs'ka State Academy of Civil Engineering and Architecture (Vol.2016, No. 9)

Publication Date:

Authors : ; ; ;

Page : 36-41

Keywords : slide bearings; friction pairs; pairs “pin ? liner”; “pivot ? liner”; friction torque; mean radius;

Source : Downloadexternal Find it from : Google Scholarexternal

Abstract

Until now slide bearings are used widely in engineering. But the calculation is made on obsolete method that is based on undetermined parameters such as wear of the bearing shell. It is accepted in the literature that if the shaft and liner material are homogeneous, the workpiece surface are cylindrical as they wear and contact between them occurs at all points contact arc. Research objective. The purpose of this study is determine a friction torque in the slide bearings of power-basis parameters. Conclusions. Since the friction is primarily responsible for wear of cinematic pairs “pin ? liner” and “pivot ? liner” slide bearings. It is shown that the friction torquesof angles wrap, that are obtained by the formulas and given in literature, are not only qualitatively but also quantitatively, namely, the calculation by literature to the formulas the friction torques are proportional to the angle wrap and the calculation by improved formulas the friction torques are inversely proportional to the angle wrap due to the reduction the normal pressure. Underreporting friction torque at large angle wrap is between 40 and 15 %. The difference in the magnitude of friction torque in the run-in and run-out cinematic pairs with real method of machining is 2...3 %, which it is possible to declare of reducing the finish of contacting surface of slide bearings.

Last modified: 2017-01-18 18:18:31