OPTIMIZATION OF PROCESS PARAMETERS USING AHP AND VIKOR WHEN TURNING AISI 1040 STEEL WITH COATED TOOLS
Journal: International Journal of Mechanical Engineering and Technology(IJMET) (Vol.8, No. 1)Publication Date: 2017-01-01
Authors : D. Bhanu Prakash; G. Krishnaiah;
Page : 241-248
Keywords : AHP; VIKOR; Fuzzy linguistic variables; PVD Tool; CVD Tool; Optimization; Turning.;
Abstract
In our previous work, optimal machining parameter selection during turning of AISI 1040 steel using coated tools with the help of Taguchi Method as well as the use of MCDM techniques TOPSIS with AHP were discussed. The disadvantage of Taguchi Method and the advantage of MCDM technique i.e. TOPSIS with AHP were demonstrated and optimal parameter selection was done. In the current work, MCDM technique VIKOR in combination with AHP is used to optimize machining parameters. It was found that the result is in good agreement with that obtained when using TOPSIS with AHP for the same. The current article demonstrates the application of VIKOR with AHP using CVD coated cutting tool data. The same was applied for the data obtained using PVD coated tool.
Other Latest Articles
- EVALUATION OF PRECAST TECHNOLOGY ON PROJECT PROFITABILITY
- EVOLUTION OF SUPPLY CHAIN MANAGEMENT WITH EMERGING TECHNOLOGIES
- PROCESS OPTIMIZATION IN DRY TURNING OF STEEL, CAST IRON AND BAKELITE USING LOW COST TOOL MATERIAL
- MODERN VEHICLE FOR THE PHYSICALLY CHALLENGED PEOPLE USING BLUE EYE TECHNOLOGY
- OPTIMAL RESOURCES UTILIZATION IN CONSTRUCTION INDUSTRY
Last modified: 2017-02-18 19:21:59