An Experimental Investigation on Mechanical Behaviour of SiCp Reinforced Al 6061 MMC using Squeeze Casting Process
Journal: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) (Vol.7, No. 6)Publication Date: 2018-12-31
Authors : Maharshi Singh L. Natrayan; M. Senthil Kumar;
Page : 663-668
Keywords : Aluminium 6061; SiC; Squeeze Casting Technique; MMC; Volume Fraction & Mechanical Characterization;
Abstract
Currently, Aluminium (Al) 6061 material is used in Automobile and industry applications, Al 6061 matrix material gives good formability with excellent mechanical properties. Reinforcement of distribution is a major problem in some casting methods and to overcome this casting problem, squeeze casting technique was used in this research work, where Aluminium 6061 act as a matrix material and SiCp was used with different volume percentage. The effects of volume in ractions of reinforcements on the composite properties were investigated. The micro structural characterization results revealed a homogenous distribution of SiC particles in the matrix, which is almost free of pores can be obtained by squeeze casting method. The mechanical characterization revealed that the density, hardness and impact energy of composites increased while increasing the percent volume fractions of SiC particles
Other Latest Articles
- Design of Compliant Mechanisms for New Age Industry Devices –A Topology Optimisation Approach
- Effects of Ultraviolet Radiation with and Without Heat on the Fatigue Behavior of Below-Knee Prosthetic Sockets
- Electrical Flight Technology-A Short Review and Challenges
- Engine Performance and Emission Characteristics of 1-Octanol Blended Bio-Diesel in a Single Cylinder Diesel Engine
- Influence of Moisture Absorption and their Effect on the Physico-Mechanical Properties of Coir-Luffa Fibre Reinforced Polymer Matrix Composites
Last modified: 2018-01-13 20:53:38