Numerical and experimental investigations of steel-concrete beams with thin-walled section

Introduction. Conducted is to the evaluation of the stress-strain state of the steel-concrete beams with thin-walled section. In recent times, steel-reinforced concrete structures have become widely used in civilian buildings (beams, slabs, columns). Thin-walled section have not found wide application in steel concrete structures, unlike steel structures. Presents the results of numerical studies of beams consisting of concrete, anchors and steel beams. Two investigating of the location of anchors are given. Numerical investigations are presented of steel-concrete beams with thin-walled section based on numerical studies. Testing procedure and test result are given. Results of calculations, comparison of numerical and experimental studies are presented. Materials and methods. For full-scale experiments, steel I-beams with filling of side cavities with concrete were adopted, screws are used as anchor ties, with varied both the lengths and their location (vertically and obliquely). As steel curved C-shaped steel profiles were used steel profiles from the range of the company “Steel Faces”. ANSYS software package was used for computer modeling. A total of 16 steel concrete beams were considered, for which the results of strength and stiffness evaluation were obtained in ANSYS. Results. The data of the stress-strain state of beams on the basis of computer simulation are obtained. The results are used for the production of field samples. Data of computer simulation are compared with the indicators of field experiments. Conclusions. The stress-strain state of steel-concrete structures was studied on the basis of numerical and experimental data. The proposed calculation method gives good convergence with the experimental data. Anchor connections made from self-tapping screws can be used in studies for modeling in steel-concrete beams structures and other anchor devices, ensuring the joint operation of concrete and steel profiles in structures.