POWER QUALITY OF A SMART GRID USING MPPT AND PWM TECHNIQUE
Journal: International Journal of Electrical Engineering and Technology (IJEET) (Vol.11, No. 2)Publication Date: 2020-04-30
Authors : MD ASIF SARDAR ALI AND.N SAMBASIVA RAO;
Page : 95-106
Keywords : HRES; BESS; MPPT; PWM; voltage source converters.;
Abstract
In this paper A Renewable Energy system, Hybrid type using wind and Solar Energy system is proposed. Here two back to back converters using IGBT are interfaced with Permanent Magnet Synchronous Generator (PMSG) and Photo Voltaic Systems (PV) connected to linear load. A capacitor is connected between the Back to Back converters to maintain a steady voltage and to reduce the ripples. A Battery Energy storage system (BESS) is connected between the back to back converters. Battery Energy storage system gets charged when wind and PV energy is sufficient to the load and it Supplies when required by the load. Maximum Power point Tracking (MPPT) technique is implemented as a control mechanism for wind and PV systems to maintain unity power factor at the PMSG by controlling the generator side converter .and to improve the power quality. MATLAB/SIMULINK software is used to simulate the results to verify the impact of control strategies on the system for variable wind speeds and variable irradiance.
Other Latest Articles
- COMPARATIVE ANALYSIS FOR ENERGY AUDIT OF ACTUAL MONITORED AND SIMULATION BASE 100/22KV TRANSMISSION SUBSTATION
- PROTECTION OF DISTRIBUTION SYSTEM USING SMART ISOLATION TECHNIQUE
- CONVENTIONAL IC ENGINE TO BLDC POWERED ELECTRIC MOTORCYCLE CONVERSION E MOTORCYCLE
- DETERMINATION OF CLOSEST SADDLE NODE BIFURCATION POINT FOR POWER SYSTEM USING SINE COSINE AND RAO-1 METAPHOR-LESS ALGORITHMS
- SMART FAULT DETECTION IN DISTRIBUTION SYSTEM
Last modified: 2020-05-02 18:40:03