MACHINABILITY ANALYSIS OF TITANIUM ALLOYS USING DIGRAPH AND MATRIX METHOD FOR COMMON MACHINABLE TOOL INSERTS
Journal: IMPACT : International Journal of Research in Engineering & Technology ( IMPACT : IJRET ) (Vol.3, No. 8)Publication Date: 2015-08-20
Authors : SEBIN JAMES; K SANTHOSH KUMAR; ARUN M;
Page : 51-58
Keywords : Titanium Alloy; Digraph and Matrix Method; Milling Insert; Machinability;
Abstract
In this research Ti6Al4V in annealed and solution heat treated condition are taken for machinability analysis. The machinability of Ti6Al4V alloys is analyzed using Digraph and Matrix method, with different grades, geometries and load capacity of inserts mainly used in industry. For machinability analysis of alloys, it is found out by conducting slot milling operation with a constant speed, feed and depth of cut for all combination of tool and work piece and the response taken are surface roughness, material removal rate and cutting power. For machinability analysis both round and rectangular geometry inserts of sandvick with grades GCS30T, GC1030 and GC4020 are used
Other Latest Articles
- DEVELOPMENT OF SILICON CARBIDE REINFORCED ALUMINIUM METAL MATRIX COMPOSITE FOR HYDRAULIC ACTUATOR IN SPACE APPLICATIONS
- MACHINING PARAMETERS OPTIMIZATION IN END MILLING OF Ti6Al4V USING TAGUCHI METHOD
- Two-Terminal Low-temperature Poly-Si Thin Film Non-Volatile Memory
- Pre-stress and Free Vibration Optimization of Composite Ocean Current Turbine Blade
- Improving the deformation warping European regulatory battery holder by using mold analysis and Taguchi method
Last modified: 2015-09-18 19:45:59