Concepts of increasing productivity and reducing the processing cost of machine parts

The basic conditions to reduce the cost of processing technology and improve productivity through the use of modern cutting tools produced by leading foreign firms producing tools have been appraised from theory in the work. Theoretically, it has been found that an increase in the cost of processing varies according to extremum dependence, passing the minimum point. It is possible to reduce the minimum processing cost due to the increase of productivity using cutting edge tools, characterized by a high capacity for work in high cutting temperatures. The criterion showing the technological price cost minimum is the ratio of the expenditures on workers' wages to the expenditures on the cutting tools, it being quite specific for various processing conditions. To analyze the possibilities of practical use of the proposed criterion, a complex of experimental researches of the technological prime cost and productivity of the processing with hard alloy cutting tools with wear-resistant coatings produced by the company «Iscar» has been carried out. It has been established that their use makes it possible by more than one half to reduce the labour consumption and overall costs as compared to the hard alloy cutting tools traditionally used in home industry. It has been shown that this effect is achieved by increasing the cutting speed and feed due to increased wear resistance and heat resistance of the «Iscar» company tools. It was established that it is much more possible to achieve low processing cost at milling than at turning. It was stated with regard to all major expenditures including the workers' wages, the cost of the cutting tools, equipment and other costs, allowing more correctly estimate the cost-effectiveness of mechanical processing. Experiments confirmed that the main condition for reducing the processing cost to its minimum value is to increase the processing performance through the use of a heat-resistant and wear-resistant cutting tools. Practical recommendations for improving the machining of machine parts have been made