THE APPLICATION OF TAGUCHI’S OPTIMIZATION METHOD IN WET TURNING OPERATION OF EN 19 STEEL
Journal: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) (Vol.3, No. 2)Publication Date: 2013-06-30
Authors : RAHUL DAVIS VIVEK JOHN VIVEK KUMAR LOMGA; RAJA PAUL HORO;
Page : 193-198
Keywords : EN-19 Steel; Turning Operation; Surface Finish; Taguchi Method;
Abstract
The present work is associated with turning operation of En-19 steel. The paper represents the influences of five different cutting parameters like pressurized coolant jet, rake angle, depth of cut, spindle speed and feed rate on the surface roughness of the En-19 steel. In the experiment Taguchi technique was used to calculate the various readings by using MINITAB15 software. Orthogonal L16 array was used and signal to noise ratio and the analysis of variance (ANOVA) are employed to interpret the cutting parameters. The carbide tipped tool having negative and positive rake angle according to the combination of the experiment was used. The measured results were then collected and analyzed with the help of software called MINITAB15. The experiment setup included spindle speed of 780 and 1560 rev/min, pressurized coolant jet of 0.5 and 1 bar, rake angle 4 and 7 degrees, depth of cut of 0.5 and 1 mm and feed rate 0.16 and 0.8 mm/rev. At last confirmation test was done to compare the value with final outcome to confirm the effectiveness of the surface roughness of En-19 steel.
Other Latest Articles
- THEORETICAL STUDY AND FINITE ELEMENT ANALYSIS OF CONVECTIVE HEAT TRANSFER AUGMENTATION FROM HORIZONTAL RECTANGULAR FIN WITH CIRCULAR PERFORATION
- MODELLING OF METAL FORMING PROCESS FOR SIMULATION PROCESS
- RECENT STUDIES ON SINGLE PHASE FLUID FLOWS AND HEAT TRANSFER IN MICROCHANNEL - A REVIEW
- STUDY OF PISTON SLEEVE MANUFACTURED BY SAND CASTING PROCESS TO REDUCE REJECTION RATE USING SIMULATION SOFTWARE
- DESIGN OF FEED DRIVE SYSTEM OF SPECIAL PURPOSE CNC TURNING MACHINE
Last modified: 2013-07-26 20:07:30